Graziano sag 14 manual11/20/2022 ![]() Plus, of course, all the other bits you see. Both the original steadies, the original 12" 4 jaw (think the 3 jaw currently on it is likely also the original), the original set of quick change holders (plus a few, like the MT2 holder with the little centre in it!), the riser block/rear toolpost for the cross slide, and bits for the taper turning attachment. 13 change gears, including the ones on the machine - not that you actually need any change gears for 99% of the time, as the Graziano has a true metric/imperial quick change box. I believe I have almost every single accessory this machine was shipped with from the factory. Of course, used lathes are only as good as the tooling you get with them. ![]() ![]() Sorry to disappoint those of you eagerly awaiting Project Banarama: Part the second, but that ain't gonna happen - I took the "easy" way out.:roll: ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |